This interface allows to use a Calypso based phone (e.g. Motorola
C1XX) as a SIM card reader. It basically implements a few L1CTL
messages that are used to interact with the SIM card through
the OsmocomBB 'layer1' firmware.
Please note, that this is an experimental implementation, and
there is a risk that SIM programming would fail. Nevertheless,
I've managed to program and read one of my SIMs a few times.
Change-Id: Iec8101140581bf9e2cf7cf3a0b54bdf1875fc51b
The method send_apdu() first transmits the APDU in the cards direction.
The card may indicate that there is a response available by responding
with SW1=9F, where SW2 is the number of bytes. send_apdu() will then
craft a get-response APDU to pickup the response bytes. This mechanism
works fine for SIM, but USIM uses SW1=61 to indicate the availability
of a response, so lets also sense on SW1=61 to support USIMs as well.
- Also check on SW1=61 to see if a response is available
Change-Id: Ied7fb78873a7c4109de471c7a5e9c3701ba0c7d5
Related: SYS#4245
The method send_apdu_checksw() is used to check the SW of the final
response against some pre defined value. However, in many cases the
last two digits of the SW are used to return varying information
(e.g. length information or a more specific status info). To cover
those cases it would be helfpul to define status words that contain
wildcards (e.g. 61**) in order to be able to accept all SWs from
6100 to 61ff.
- When the user supplies an expected SW with wildcards, mask out
those digits in the response before comparing
Change-Id: I5bfc0522b4228b5d9b3415f6e708abcf0da0a7b7
