- tools/build_release.sh: builds the Linux tar.gz and Windows zip from a
git ref (default HEAD) using an explicit `git archive` pathspec
allowlist: decoder (__init__.py, pd.py, gsmtap_stream.py), setup/start
scripts, tools/vs_reader.py, READMEs, LICENSE and the README-referenced
resources/ images. v* tags must match pd.py VERSION. Both archives
are listed and extracted and checked for VERSION, py_compile, bash -n,
.bat CRLF / .sh LF and tar exec bits; SHA256SUMS uses sha256sum or
shasum. Builds into a staging dir and only then replaces dist/.
- .github/workflows/release.yml: on a v* tag push run the unit tests,
verify tag == pd.py VERSION, build, then upload into an existing
release or create a draft and publish it; release-<tag> concurrency.
- README/RUS: Installation documents both ways (release download
recommended; source checkout for development), SHA256SUMS verification,
and the Windows prerequisites verified against sigrok.org (0.7.2
release installer as the tested version, nightly caveat, VC++ 2010
redist, bundled fx2lafw firmware and Zadig, per-port driver binding).
- start.bat: accept --opt=value alongside the original --opt value form
(the usage text advertised the = form while the parser required a
space); usage corrected and notes the core subset.
- .gitignore: dist/.
- AGENTS: release packaging, build verification and release process
(commit docs/workflow first, then tag and push, auto-generated notes).
No decoder behavior change; VERSION stays 1.9.7.
- pd.py: remove _lock_etu_from_edges (long-disabled) and the no-op
while-True FIND START wrapper.
- pd.py: re-raise SystemError (libsigrokdecode's clean EOF signal) in the
six 'except Exception: pass' guards so put()/wait() at end-of-capture
exits cleanly instead of being swallowed.
- pd.py: fix _measure_clock_period docstring (averages, not robust-min);
drop stale 'line 1633' comment; document the synthetic pcap UDP header
(zero IP checksum / fixed loopback+ports are intentional).
- signal_diagnostic.py: add --max-samples cap + document whole-capture
RAM cost; fix stale '--rst/--vcc=ignore' guidance (-> --no-rst/--no-vcc).
- tests: make test_valid_cla_interindustry_classes use subTest (was a
no-op tuple expression).
- start.sh/start.bat: note the -A multi-spec form is sigrok-cli 0.7.x.
- Remove stale tests/baseline_new.txt (v1.1.3-era, ATR-included mode).
- Add top-level LICENSE (GPL-2.0-or-later).
- pd.py ts_from_samplenum: drop c_uint32 truncation + dead sampleOverflowCount
(pcap timestamps wrapped backwards past ~4.5 min at 16 MHz).
- pd.py handle_atr: guard None reads at EOF (was TypeError (None & 0x80) on a
capture truncated mid-ATR-hunt).
- start.bat: add --protocol (+ :protocol=T=0 default) to match start.sh's
mid-session decode; correct the 'flag-for-flag' header comment.
- start.sh: reject --rst/--vcc assigned to the same pin (was unchecked).
- setup.bat: set DEVICE_MSG on blocked/skipped probe so the trailing
'unknown' message is suppressed.
- vs_reader.py: RESULT now fails on CONCAT / payload mismatch / suspicious
CLA, not just GARBAGE (OK text unchanged; clean traces stay identical).
Full -A iso7816 printed all annotation rows including the per-byte 'bytes'
row (thousands of lines per capture; ~22k on xiaomi_phone, ~11k on A55).
Default is now '-A iso7816=apdus,iso7816=warnings' (decoded APDUs + decoder
warnings/errors only); --debug restores the full '-A iso7816' output plus
the existing -l 4. stderr decoder log (banner, PACKETEND hex, glitches,
discards) is untouched.
Residual CONCAT mis-frames (4gmodem/A55_sim2/S21p_sim2) traced to a silent
5-byte drop at an invalid-INS T=0 header (0x0f 00 a4 08 04). Drop only the
stray leading byte and re-frame the remaining four via _replay so the real
command (00 a4 08 04 02 2f 00 -> 61 1c) is recovered.
- _note_discard()/_consume_first(): every consumed-but-unemitted byte is
now logged; idle 0x00/0xFF discards are rate-limited, real data always
gets an ANN_WARN annotation.
- All read-until-SW loops log skipped non-SW bytes.
- All traces: CONCAT 0; BAD_FCS/GARBAGE 0; test_8/test_7 RESULT OK;
47/47 unit tests; baseline byte-identical.
History rewritten to a single root commit so no example trace is stored
in the repo (fixtures are local-only, gitignored). README keeps only
generic <trace>.sr placeholders; AGENTS.md retains the fixture names.
catarrh