the ISO7816 UARTs have highest priority, while console has lowest.
remaining sources (USB, ADC, GPIO) are in between.
Change-Id: Ie6c97d61d8da3990b6e44144f36cb6d37d194307
the higher baud rate allows for more debugging (without dropping
data) and is well supported by USB for UART adapters (this
standard baud rate is 8 x 115200).
the closest matching integer value is calculated for UART CR.
no floating point calculation can be used since this would
increase the size of the resulting binary by ~ 2kB (for the
softfp). this is not possible for the DFU since it already is
close to the maximum size of 16 kB.
Change-Id: I82b74f697342d580ccb79ada4715f35f4e8cca86
The default ISR (particularly the HardFault handler) print information,
but this information was not displayed on the console because the UART
IRQ is lower than some default blocking IRQ.
Allowing to set synchronous transfer corrects this.
The underlying Atmel exception library had to be modified to use the
synchronous output.
Making UART_PutChar always synchronous when called from an ISR is not
desired because we use TRACE_ macros is some ISR. The synchronous
output must be set explicitly.
Change-Id: I1b4ace5185cf2dc32684934ed12bf6a8682e9bad
The DFU uses the UART peripheral (with IRQ/ISR) for the debug output
console. Before starting the main application we should make sure
this configuration is reset to avoid interference (particularly the
IRQ/ISR).
This is not too important though since the main application
reconfigures the UART for console output.
Other peripheral could also be disabled (e.g. all other PIO used
by DFU), but most of them also get configured by the main application.
Change-Id: I8234d1b85938ad6393094c08183f613ad09ee01b
don't wait for space to be available in the buffer since since would
prevent from processing non-console (e.g. debug) more important data
Change-Id: Ia625b09eb30bb7b43edd3989f697d8ef33200f28
This way we can easily check with 'diff' for differences in our code and
Atmel softpack. Also, this layout is more suitable for building various
different firmware images (e.g. factory-test, dfu-loader, main
application) for a variety of different boards (simtrace, owhw, qmod).
