the reset/ATR handling has been heavily updated/fixed.
instead of using the timer counter peripheral to handle
the waiting time and corresponding timeout, the USART peripheral
internal timeout mechanism is used.
this is particularly important for the SIMtrace board since the
clock signal is not connected to the timer counter.
thus this change adds card emulation support for SIMtrace boards.
Fi and Di have been properly rename to F and D since the "i"
stands only for an "indicated" value, not the actual value.
this does not change the USB protocol (the variable have just been
renamed).
additional variables store more information about the card
capabilities
NOTE: it has only be tested for the SIMtrace board
Change-Id: Ibcb2c8cace9137695adf5fb3de43566f7cfb93b5
The new SIMTRACE_MSGT_BD_CEMU_CONFIG command can be used to set/change
a bitmask of optional features that can be enabled in the simtrace
by the host software. This is useful for enabling features in the
firmware which are not supported by older host utilities.
The firmware will return the actually set/configured features in
response.
The feature bitmask is not yet used anywhere; it will be by subequent
patches.
Change-Id: I7cdd3f9171dbed45de0089defe29d2b59044bd84
previously the card RST, VCC, and CLK signal states have been initialized with
default values corresponding to an inactive reader.
this worked fine for actual inactive readers since the default values match
and would be updated when the signal changes (edge detection).
but if the reader is in another state, card activation detection could fail.
this is fixed since the actual signal values are now used during initialisation.
at the same time I changed the variable type from uint8_t to boolean since they
have only two possible states, and understanding the actual state when coding
is simpler (no need to check which integer corresponds to which state).
this change has been successfully tested on the 2 slots of OWHW board.
Change-Id: Ie9245d75d48ae93d16f97897d4fa5ad6cd402e73
this changes how ATR is handled.
the ATR is also printed when set (as important debug information).
the test is also updated to correspond to the new mechanism (
simulating the timeout before sending the ATR)
Change-Id: I69df797e2feadffa9f5f977cb71b69386cee7cd0
We now generalize the USB communiction and abandon the 'req_ctx'
structure inherited from openpcd. Instead we use the libosmocore 'msgb'
structure to handle incoming and outgoing USB tranfers. We also use
linuxlist-based msgb-queues for each endpoint.
