the */usb_strings.txt files always assumed that the first line is the
manufacturer string, followed by the product string in the second line.
However, the enum strDescNum had it the other way around. Let's fix it
by adjusting the enum to reality.
Fixes: SYS#3591
msg->l2h should always point at the first byte of the header after the
generic simtrace header. For some reason this doesn't work if used
globally, but it is required for the MSGC_MODEM messages to be
interpreted correctly.
The current protocol was card-emulation specific. The new protocol is
generic/flexible enough to accommodate both tracing and card emulation,
as well as modem control and other future extensions.
We now generalize the USB communiction and abandon the 'req_ctx'
structure inherited from openpcd. Instead we use the libosmocore 'msgb'
structure to handle incoming and outgoing USB tranfers. We also use
linuxlist-based msgb-queues for each endpoint.
This was introduced for interoperability with operating systems that
might prefer such setup (I heard that Windows prefers this about a
decade ago, but I don't have any personal experience with it).
However, using different VID/PID between DFU and RT breaks usability of
dfu-util, and I really think this matters much more to our users and
developers.
the default boot state should be to use the local SIM, until the user
changes it (currently only possible via entering '!' or '@' on the
serial console). The code so far had this completely inverted.
We cannoy simply use the DFU runtime descriptor of the DFU mode, but we
have to use the descriptor of the specific currently-selected runtime
configuration. Let's iterate over the descriptors of a configuration
and find the DFU runtime descriptor in it.
At power-up we need to initialize g_dfu once, to ensure a consistent
state. Afterwards we want to keep it across (software) reset, but on
power-up the memory would otherwise be filled with random data, causing
issues with detection of DFU/Runtime switching.
This way, host code can dynamically detect which interface supports
which functionality.
The related #defines should be moved to a header file that's shared with
the host application code.
Actually, at device level we want to specify 0, so we can select
individual Class/Subclass values at Interface values.
Table 9-8 of the USB2 Specification is quite clear about this.
When initializing the TC blocks, let's only configure the GPIO pins TCLK
and TIOB, and not the unused TIOA pin. That pin is actually used for
(separate) different functions in both qmod and owhw.
The port mapping is now as follows:
* port 1: ST12
* port 2: modem 1
* port 3: modem 2
* port 4: ST34
* port 5: modem 3
* port 6: modem 4
* port 7: daisy-chaining port
Using the USBDFU_OverrideEnterDFU() function, a board/application can
define extra conditions when the system should boot in DFU mode, even if
it was not explicitly switched to DFU mode from the application.
The app/dfu/main.c uses this mechanism to boot into DFU mode if the
stack + reset vector addresses are not plausible (i.e. some random junk
appears to be flashed in the application partition) or if the user
places a jumper accross the RxD+TxD lines of the debug UART. The idea
is that the system can be recovered by placing this jumper and then
re-installing the application from DFU.
Sometimes there is some leakage current via some I/O that's sufficient
to power up the SAM3S. Use the supply monitor to make sure the CPU
will be reset (and kept in reset) if the supply voltage is below 3.0V.
This makes sure that we'll re-enumerate on the USB, as a CPU reset
apparently doesn't automatically release the pull-up and notify the hub
that we were gone?
