The qmod does not have a separate force button as simtrace has.
Instead it check is TX and RX of UART are shorted using PIO.
If the pins are not set back to the UART peripheral, the TRACE/debug
console output will not work anymore.
Change-Id: Id434b49909d6395a2f93a00f39d2d770a5725466
The DFU uses the UART peripheral (with IRQ/ISR) for the debug output
console. Before starting the main application we should make sure
this configuration is reset to avoid interference (particularly the
IRQ/ISR).
This is not too important though since the main application
reconfigures the UART for console output.
Other peripheral could also be disabled (e.g. all other PIO used
by DFU), but most of them also get configured by the main application.
Change-Id: I8234d1b85938ad6393094c08183f613ad09ee01b
The stack size is fixed. The linker script puts the stack section
after the bss section. The initial stack pointer is not at the
end of the RAM (as often seen).
Thus the initial stack pointer address of the main application
is different than the one from DFU. When starting the main
application the stack pointer needs to be set to the new value.
If this is not done the main application stack may overwrite the
data in bss, even without exceeding the fixed stack size.
Change-Id: Ie354d603fe302d3d5bdfa9c31575411de722323b
In the SIMtrace and QMOD schematics the LEDs are connected to +3.3V.
Thus to switch the LED on we need to set the pin low.
Change-Id: Id8cc27e6f0b6556ba5e7ea4d254dd0fe59042a0c
don't wait for space to be available in the buffer since since would
prevent from processing non-console (e.g. debug) more important data
Change-Id: Ia625b09eb30bb7b43edd3989f697d8ef33200f28
Use USART 0 connected to the SIM card side to sniff the communication.
The card side can also measure ETU times.
Do proper pin initialization.
This code can already capture the ATR communication between phone and card.
Change-Id: I0597ec723cb2225540c89c3821b91d8a45adfcd6
the curent local copies of libosmocore headers + source is a temporary
hack anyway. We should instead rely on a system-wide install of
libosmocore cross-compiled for arm-none-eabi. But leave that as a
second (later) step beyond this patch.
Change-Id: Ia63fd842d45a2b404233b4326050e7eda0604cf0
fixes following warning:
libboard/common/source/board_cstartup_gnu.c:137:11: warning: assignment to 'void (*)(void)' from 'unsigned int' makes pointer from integer without a cast [-Wint-conversion]
appReset = pSrc[1];
The original board startup script is provided by Atmel.
It has been modified to handle application or DFU booting.
The copyright notice has been updated to reflect this change.
Each board can define its own conditions on which the controller should
boot into DFU mode rather than normal application mode. Let's move the
"UART loopback jumper" to QMOD specific part. For SIMtrace we have an
actual button and can use that in a future patch.
The logic to detect if the respective module is already initialized
or not was broken. When performing initialization, we of course need
to set initialized=1.
We now generalize the USB communiction and abandon the 'req_ctx'
structure inherited from openpcd. Instead we use the libosmocore 'msgb'
structure to handle incoming and outgoing USB tranfers. We also use
linuxlist-based msgb-queues for each endpoint.
