octsimtest has a resistive voltage divider in front of the VCC ADC
in order to also detect 5V. We must make the thresholds board-specific
and adjust them for octsimtest.
Change-Id: I9e4adb4f349d2d838ea4100eb49271f3a0e7a2a5
Contrary to other hardware designs, octsimtest has a level-shifter in
the I/O line to support testing with 1.8, 3 and 5V. This level shifter
is bi-directional, but the direction needs to be explicitly specified
via the SIM_IO_DIR signal attached to PA26.
Change-Id: I44171363b5bd69d6049b12c86f8143be83557cb2
* code for controlling the Card slot + frequencyt divider muxes
* put everything in place to build cardem application for it
Change-Id: I7e03e0c0f2999a1ce2dad966d98e22033fa58465
The octsimtest board only supports cardem mode, not 'ccid'
nor 'sniffer'. Remove related GPIO pin #defines from board.h
Change-Id: I43e8631d945ba183a1e5b1e37dd4565adb377154
the OctSIM tester has only one amber LED.
this is now mapped to the normally green LED, used for activity.
because the LED is driven by an NPN transistor (as open collector)
instead of being directly connected to the pin (as open collector)
like on the other boards, the logic is inverted.
since normally the LED is on on idle and blinks during activity,
it will now be off on idle an only blink on activity (unless the
code is extended to cope with the possible inverted logic).
because there is no second LED but the current code requires one,
I mapped is to an unused pin.
the octosimtest target still does not compile completely, but at
least the LED issue is fixed.
Change-Id: I1296833bef2804c611640fcf4756e47905660e7b
