Harald Welte eb8fbc0296 fw/qmod: enable modem RESET by default at boot ...

When the uC firmware starts, assert the (high-active) _RESET GPIOs,
which will cause the transistors to drive the mPCIe slot !PERST
low.

There is of course a short instance of time between the uC reset
until it executes wwan_perst_init(). To avoid this, a hardware
pull-up would have to be re-worked onto the _RESET[1..4] signals
on the PCBA

Change-Id: I8742fefa4bf02e728e34d5d8cbc0fda771e78ffb

2021-06-06 11:46:50 +02:00

..

common

make sim switch board specific

2021-04-08 21:28:37 +00:00

octsimtest

firmware: octsimtest: ensure all card_insert GPIO are 0 after reset

2021-06-06 11:46:49 +02:00

owhw

make sim switch board specific

2021-04-08 21:28:37 +00:00

qmod

fw/qmod: enable modem RESET by default at boot

2021-06-06 11:46:50 +02:00

sam3p256

make LED definitions board specific

2019-10-04 15:55:02 +00:00

simtrace

simtrace board.h: Enable HAVE_CARDEM if we build the cardem firmware

2021-06-01 18:38:21 +02:00