Harald Welte e974fbb9e5 Issue ST12_PRTPWR_OVERRIDE before putting hub in reset ...

When we reset the hub, the hub will actively drvie the PRTPWR signal of
the SITMRACE12 low, resulting in the SAM3 being shut off.  If we want to
"survive" this, we need to set the OVERRIDE before we go into reset.

Right now, we never release the signal again, keeping ST12 enabled
permanently, which is of course not what we want in general.

2016-10-19 19:36:07 +02:00

..

atmel_softpack_libraries

USBDDriver.c: swaped args to memset

2015-05-08 16:45:15 +02:00

cmsis

Removed sym links, replaced them with actual folders

2015-04-07 20:04:19 +02:00

include_board

Issue ST12_PRTPWR_OVERRIDE before putting hub in reset

2016-10-19 19:36:07 +02:00

include_sam3s

read SAM3S unique serial number at start and print it

2016-03-20 16:00:39 +01:00

openocd

Renamed main folder to firmware

2015-04-07 18:24:06 +02:00

src_board

Add support for 'qmod' (quad-modem) board

2016-08-21 18:32:12 +02:00

src_sam3s

Add HardFault Exception Handler

2016-03-20 18:19:35 +01:00

src_simtrace

Issue ST12_PRTPWR_OVERRIDE before putting hub in reset

2016-10-19 19:36:07 +02:00

test

ensure usb_msg_hdr contains raw message length

2016-03-18 21:01:36 +01:00

flash.ld

Renamed main folder to firmware

2015-04-07 18:24:06 +02:00

Makefile

WIP: bit-banging I2C support for EEPROM access on QMOD

2016-08-21 19:33:24 +02:00