introduce support for new ngff_cardem board

This adds support for the new ngff_cardem board, a board that
basically combines a ngff breakout board with a built-in SIMtrace2.

Cardem works, but depending on the modem it might need a adjusted ATR to
ensure a lower baud  rate is used by the modem, high rates might lead
to weird power cycling of the card after a few transfers.

Trace was also tested and appears to work as expected.

Change-Id: Ia96124fbe8a752c98e7fd4096d542a3b2b9bc255

firmware/apps/cardem/main.c

@@ -71,8 +71,13 @@ static const conf_func config_func_ptrs[] = {
 		.init = mode_cardemu_init,
 		.exit = mode_cardemu_exit,
 		.run = mode_cardemu_run,
+#if defined (ngff_cardem)
+		.usart0_irq = mode_cardemu_usart1_irq,
+		.usart1_irq = mode_cardemu_usart0_irq,
+#else
 		.usart0_irq = mode_cardemu_usart0_irq,
 		.usart1_irq = mode_cardemu_usart1_irq,
+#endif
 	},
 #endif
 #ifdef HAVE_MITM