fixes following warning:
libboard/common/source/board_cstartup_gnu.c:137:11: warning: assignment to 'void (*)(void)' from 'unsigned int' makes pointer from integer without a cast [-Wint-conversion]
appReset = pSrc[1];
adc2uv is not used in boardver_adc.c.
a FIXME comment says it should be shared with mode_cardemu.c.
the exact same code is already available in mode_cardemu.c
The original board startup script is provided by Atmel.
It has been modified to handle application or DFU booting.
The copyright notice has been updated to reflect this change.
Each board can define its own conditions on which the controller should
boot into DFU mode rather than normal application mode. Let's move the
"UART loopback jumper" to QMOD specific part. For SIMtrace we have an
actual button and can use that in a future patch.
The logic to detect if the respective module is already initialized
or not was broken. When performing initialization, we of course need
to set initialized=1.
This was introduced for interoperability with operating systems that
might prefer such setup (I heard that Windows prefers this about a
decade ago, but I don't have any personal experience with it).
However, using different VID/PID between DFU and RT breaks usability of
dfu-util, and I really think this matters much more to our users and
developers.
Using the USBDFU_OverrideEnterDFU() function, a board/application can
define extra conditions when the system should boot in DFU mode, even if
it was not explicitly switched to DFU mode from the application.
The app/dfu/main.c uses this mechanism to boot into DFU mode if the
stack + reset vector addresses are not plausible (i.e. some random junk
appears to be flashed in the application partition) or if the user
places a jumper accross the RxD+TxD lines of the debug UART. The idea
is that the system can be recovered by placing this jumper and then
re-installing the application from DFU.
Sometimes there is some leakage current via some I/O that's sufficient
to power up the SAM3S. Use the supply monitor to make sure the CPU
will be reset (and kept in reset) if the supply voltage is below 3.0V.
It is utterly unacceptable that Atmel is shipping example code in 2011,
which doesn't support parts that are shipped still in 2016. They would
have had five years to fix their code to implement the chip errata :(
We need to refer to g_dfu as a pointer from all code. In DFU mode, it
gets assigned to the address of _g_dfu, which is placed by the linker
script at the start of RAM. In runtime mode, the pointer is statically
defined to point at the start of RAM. The linker script for the runtime
(dfu environment) is adjusted to save the first 32 bytes for the _g_dfu
structure.
* we now actually route the EP0 control requests in DFU mode to the
correct handler (weak linker symbols are tricky)
* we now actually call code to read/write data from/to RAM/FLASH
This way we can easily check with 'diff' for differences in our code and
Atmel softpack. Also, this layout is more suitable for building various
different firmware images (e.g. factory-test, dfu-loader, main
application) for a variety of different boards (simtrace, owhw, qmod).
