this adds the DFU as application, allowing to flash the bootloader.
a USB DFU alternative is added to flash the bootloader partition.
when the DFU is started as bootloader, the partition/alternative
to flash the bootloader is marked as "not available", and
ineffective.
the same happens for the application partition when DFU is started
as application.
this distinction is make at compile time, not at runtime, because
of size restrictions (the bootloader was already close to the
16 kB limit).
*_dfu_flash.bin should not be mixed with *_dfu_dfu.bin.
*_dfu_dfu.bin should be flashed as application using the already
existing DFU bootloader.
once this images is started (as application), the *_dfu_flash.bin
should be flashed as bootloader using the DFU application.
once the DFU bootloader has been flashed, soft resetting
(not re-powering) will cause the bootloader to start, allowing to
flash the application with a normal image (e.g. not DFU),
replacing the DFU application.
this switch to DFU only happens after downloading (e.g. flashing).
it is planned to have the DFU application erase itself after
flashing, but this is currently not implemented.
Change-Id: Ic273bb593a7669111b0219fe301d7897419167c8
as for the main application firmware, the DFU bootloader firmware
now also has the unique chip ID as iSerial in the USB description,
and an additional empty USB configuration indicates the firmware
version (e.g. DFU bootloader version).
these are only visible when the device is in DFU mode.
Change-Id: I11a2cd8079fda374d816da180f39f1c33d10af60
Using the USBDFU_OverrideEnterDFU() function, a board/application can
define extra conditions when the system should boot in DFU mode, even if
it was not explicitly switched to DFU mode from the application.
The app/dfu/main.c uses this mechanism to boot into DFU mode if the
stack + reset vector addresses are not plausible (i.e. some random junk
appears to be flashed in the application partition) or if the user
places a jumper accross the RxD+TxD lines of the debug UART. The idea
is that the system can be recovered by placing this jumper and then
re-installing the application from DFU.
We need to refer to g_dfu as a pointer from all code. In DFU mode, it
gets assigned to the address of _g_dfu, which is placed by the linker
script at the start of RAM. In runtime mode, the pointer is statically
defined to point at the start of RAM. The linker script for the runtime
(dfu environment) is adjusted to save the first 32 bytes for the _g_dfu
structure.
