SIM_PWEN and VCC_FWD are signals specific to the simtrace boards.
the corresponding pins PA5 and PA26 are used for other signal
on the octsim-tester.
Change-Id: I51f37dd112cf681f4b1dbb3d2320ff9a697eaa08
UART baud rate is main clock (MCK) divided by CR*16.
The MCK values are chosen >= 48 MHz and <= 64 MHz to have a near
integer value CR for a baud rate of 921600 bps.
The end MCK frequency between simtrace and qmod differ slightly
but are close to 58 MHz.
Change-Id: Iaa4a97fc68494c93b9d128503515d88049de506c
USB reset can be signaled by pulling low USB D+ for at least 10 ms,
according to the USB specification. This force a re-enumeration.
This time is increased to 20 ms to work with more USB HUBs.
Some SAM3S based board have external D+ pull-up mechanism (such as
SIMtrace) which needs to be used to pull D+ low.
This is a legacy mechanism from SAM7S history.
This mechanism is not required anymore on the SAM3S, and the qmod
does not use it. When the USB HAL is suspended, the transceiver is
disabled, causing D+ and D- to be pulled low. Then the HAL is activated
again. This is particularly required when DFU is started (and
enumerated), and after flashing the SAM3S switched to the main
application (without reset), so it can properly re-enumerate.
This board difference is now defined on the board header.
Change-Id: I9b58d8101c2fcf5595026b675728826af26127a3
Use USART 0 connected to the SIM card side to sniff the communication.
The card side can also measure ETU times.
Do proper pin initialization.
This code can already capture the ATR communication between phone and card.
Change-Id: I0597ec723cb2225540c89c3821b91d8a45adfcd6
the curent local copies of libosmocore headers + source is a temporary
hack anyway. We should instead rely on a system-wide install of
libosmocore cross-compiled for arm-none-eabi. But leave that as a
second (later) step beyond this patch.
Change-Id: Ia63fd842d45a2b404233b4326050e7eda0604cf0
This way we can easily check with 'diff' for differences in our code and
Atmel softpack. Also, this layout is more suitable for building various
different firmware images (e.g. factory-test, dfu-loader, main
application) for a variety of different boards (simtrace, owhw, qmod).
