bb9b0dc8e8
The freq_ctr app is a small application that is implementing a simplistic direct-mode frequency counter using the internal 32.768kHz oscillator and two TC blocks. One of them is used to generate a 1Hz signal, which is then subsequently used by the other TC to trigger a counter read after exactly 1s. This is in itself not something useful on a simtrace2 device. However, it is a separate 'app' and I prefer to have the code here in master over some obscure branch that's easy to forget about. Change-Id: I2249bfb8dd6a88d85d406f3b33537377133d0939
SIMtrace v2.0
This is the repository for the next-generation SIMtrace devices, providing abilities to trace the communication between (U)SIM card and phone, remote (U)SIM card forward, (U)SIM man-in-the-middle, and more.
This is under heavy development, and right now it is not surprising if things still break on a daily basis.
NOTE: Nothing in this repository applies to the SIMtrace v1.x hardware or its associated firmware. SIMtrace v1.x is based on a different CPU / microcontroller architecture and uses a completely different software stack and host software.
Supported Hardware
At this point, the primary development target is still the OWHW + sysmoQMOD device, but we expect to add support for a SAM3 based SIMtrace hardware board soon.
The goal is to support the following devices:
- Osmocom SIMtrace 1.x with SAM3 controller ** this is open hardware and schematics / PCB design is published
- sysmocom sysmoQMOD (with 4 Modems, 4 SIM slots and 2 SAM3) ** this is a proprietary device, publicly available from sysmocom
- sysmocom OWHW (with 2 Modems and 1 SAM3 onboard) ** this is not publicly available hardware, but still supported
This Repository
This repository contains several directory
- firmware - the firmware to run on the actual devices
- hardware - some information related to the hardware
- host - Programs to use on the USB host to interface with the hardware